Defense & Aerospace
Defense & Aerospace Heating Solutions
High-reliability heating and ground-support equipment for harsh environments
Industry Characteristics & Heating Challenges
Vehicle, airborne and field-support equipment imposes extra requirements on vibration, shock, wide temperature range and EMC. Heating assemblies use ruggedized structures and redundant protection, with terminal housings designed to the environmental protection level. Each unit is tested for insulation, dielectric strength, vibration and thermal cycling before shipment, with full process records retained.
Typical Applications
- Vehicle shelters and shelter air conditioning
- Radar and electronics temperature control
- Aviation ground-support vehicles
- Field fuel preheating
- Special power-supply cooling and preheat
Questions We Ask During Selection
- Q1Exact composition and concentration of the medium, and whether it is corrosive, scaling or prone to polymerization.
- Q2Whether heating is intermittent or continuous, and the required heat-up time.
- Q3What explosion-proof zone the site falls into, and how gas group and temperature class are classified.
- Q4Material, pressure rating and available installation opening size of the vessel or pipe.
- Q5Whether the power supply can handle the high-power load, and whether soft start or power regulation is needed.
- Q6Maintenance cycle and cleaning method, which determine whether the structure is withdrawable or fixed.
Within the same industry, heating requirements can vary greatly between processes. Sending us your specific operating conditions saves more time than selecting against a catalog.
+86 515 8888 6688Commonly Used Products in This Industry
View All Products →
Flanged HeatersFlanged Immersion Heater
HYF Series
A bundle-type immersion heater with a standard flange mounting interface, suited to pressurized vessels and high-power process heating, and withdrawable as a complete assembly for service.
- Power
- 3 – 500 kW
- Temp
- Ambient – 600°C
Screw Plug HeatersScrew Plug Immersion Heater
HYS Series
A compact heater that screws into the vessel wall; the small bore suits low- to medium-power tanks and pipe tracing.
- Power
- 0.5 – 36 kW
- Temp
- Ambient – 400°C
Circulation & Inline HeatersInline Circulation Heater
HYC Series
Inline vessel heating—medium flows through continuously and heats up, integrating temperature control, over-temperature protection, and flow interlock for turnkey connection to piping.
- Power
- 6 – 300 kW
- Temp
- Ambient – 350°C
Send us your operating parameters and get a selection and quote within 48 hours
Medium, temperature, power and mounting method — four details are enough to start the design. Complex duties are handled directly by our engineers.